ONLY FULL VERSION

 

This command allows the creation of an alignment based on the points acquired with the receiver. To this end there must be a (*.EJE) file in the project.

 

     What's more, it simultaneously allows the creation of the longitudinal profile files (*.LON) and the vertical alignment (*.RAS).

 

The station and the coordinates of the point read will be shown at all times.

 

 

         

 

 

Each recorded point is stored in the points' file, the first point will be recorded with the code SAL I, AlignmentFileName, Code and the rest of the points with the code SAL, Code. The corresponding data is recorded in the alignment file.

 

With the graphic option, in addition to the elements stated in the introduction to the chapter, the polyline which forms the alignment will be shown. The  button allows the points acquisition to be undone.