Allows a cross section file to be created, modified in line with the following data:

 

 

 

      Initial Station

 

      Final Station

 

      Station interval

 

Elevations: Allows an alignment to be entered manually for the alignment or to take it from the project vertical alignment, where applicable. For the latter the  Aut. box must be selected A positive or negative increment can also be indicated in the Incr.box which will be added to the elevation as it has been entered manually or acquired automatically.

 

Superelevations %:  Superelevations for the left and right-hand sides of the alignment. If the Aut. box is marked, they will be taken from the superelevation file, where applicable.

 

Plat. Width: Widths for the left and right platforms.

 

Slope x/y: Cutting and fill slopes on the left and right. The x /y value must be entered. A negative value indicates fill and positive, cutting.

 

Once all the data has been entered, the name of the file where the profiles created will be stored is requested. In addition, this file is established as an active cross section.

 

If there is an alignment file in the project, the Initial Station and Final Station boxes are filled automatically with the current alignment values.